This is what you have to do after each chip added. Inside tool menu (in settings), you can test your memory. You can see after the last chip that XblastOS show 128 Mib. Step6: I have to confirm that everything is ok and check memory inside operating system. It is a bit hard to remove all as I worked for a long time on chip N☄. And it worked, I could go on with the last one.įor people upgrading their Xbox, don't forget that a chip can fail even if it is new like for me if you realize bad solder and make a short circuit.Īs you can see, it remains some flux. So I decided to gently remove it, and to replace it with a new one. Note, that the chip N☄ gave me some problem, after test, the xbox start then stop, I check and redid the solder 3 times, after first, no boot problem on Xblast, but the chip was not anymore detected. With help of my xblast lite, one chip after another. Step5: And why don't adding more ram, this board is very nice. This is the grey primer, after I put what I use black or white paints. Step4: Shield painting to prevent corrosion (EMI points will be paint removed after painting). Step2: Hot water and soap cleaning in the kitchen on plastic parts I immediately removed clock capacitor (Yes a gamegear is also lying on the ground) and change thermal paste. It was very dirty, this is a 1.1 version. This time I took the time to give you some photos of my madness: I have started a new Xbox ( My wife will kill me).
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |